mr2 turbo fjusker ved gasspågivning over kvart pedal
Legg innLagt inn:03 apr 2015 11:55
har problemer med at mr2'n min ikke vil gå skikkelig over kvart pedal den hoste å spytter flammer å kommer smell fra eksosen hvis e prøver å gi over kvart gass
her e tråden min på imoc
http://www.imoc.co.uk/forums/viewtopic. ... 07#1621007
her e va som e blitt gjort det siste, all info ligger på imoc tråden min
finally got the engine started yesterday, after i switched dump valve and fitted a resirc to the air intake pipe, i also changed the Air Intake Pipe because my old rubber pipe was cracked, and after i did that the car ran almost perfect, for a couple of runs, and then i went inside the house to eat, and got outside again to drive a little, but then it went back to the problems i had originally, that when i gave more than quarter throttle it would cough... and shoot flames and loud bangs from the exhaust
and today i got the ecu error code, but did not get any wiser there since the only code i got was
Code: 43
System: Starter Signal
Diagnosis: No STA Signal to ecu unit engine speed reaches 800rpm with vehicle not moving
so to recap what i have done to this point
-changed sparkplugs
-checked the distributor
-checked if fuel flows to the fuelfilter
-changed dumpvalve and fitted a resirc hose to the intake pipe
-changed the Air Intake Pipe since it was cracked
anybody have more ideas of what it could be?
og er det bare 92 turbo ecu som kan brukes på den? sku gjerne fått testa om det e den siden e får feilkode på starter signal å den sier at ecu kan være ein feil på kode 43
så kansje ecu kødder til flere ting bare at eg ikke får opp kode?
her e tråden min på imoc
http://www.imoc.co.uk/forums/viewtopic. ... 07#1621007
her e va som e blitt gjort det siste, all info ligger på imoc tråden min
finally got the engine started yesterday, after i switched dump valve and fitted a resirc to the air intake pipe, i also changed the Air Intake Pipe because my old rubber pipe was cracked, and after i did that the car ran almost perfect, for a couple of runs, and then i went inside the house to eat, and got outside again to drive a little, but then it went back to the problems i had originally, that when i gave more than quarter throttle it would cough... and shoot flames and loud bangs from the exhaust
and today i got the ecu error code, but did not get any wiser there since the only code i got was
Code: 43
System: Starter Signal
Diagnosis: No STA Signal to ecu unit engine speed reaches 800rpm with vehicle not moving
so to recap what i have done to this point
-changed sparkplugs
-checked the distributor
-checked if fuel flows to the fuelfilter
-changed dumpvalve and fitted a resirc hose to the intake pipe
-changed the Air Intake Pipe since it was cracked
anybody have more ideas of what it could be?
og er det bare 92 turbo ecu som kan brukes på den? sku gjerne fått testa om det e den siden e får feilkode på starter signal å den sier at ecu kan være ein feil på kode 43
så kansje ecu kødder til flere ting bare at eg ikke får opp kode?